Protect RCS

These are the latest generation of robust, industrial rectifiers, chargers and DC Systems from AEG Power Solutions. Using proven microprocessor controlled thyristor technology to provide high-reliability power supply and battery charging capabilities. Choose from standard system configurations or customized systems, designed to comply with precise specifications.

KEY FEATURES

Input:
SPRe: 220/230/240 1-phase
TPRe: 380/400/415 3-phase

DC Output:
24V 10–1000A
48V 10-1000A
110V 10–1000A
125V 10–1000A
220V 25–1000A

• Standard or customized systems – enhanced by an extensive range of options
• Generic Control and Alarm Unit
• Monitor and control parameters locally/ remotely
• Several types of batteries:
  – Nickel-cadmium (vented/ gas recombination)
  – Lead acid (vented/ gas recombination)
• Advance battery management
• Parallel operation
• High MTBF, low MTTR
• Can also be used as direct power supply

CONFIGURATIONS

Standard system

The Protect RCS range of systems has been preconfigured with a number of the most commonly requested features built-in as standard. These systems are available “off-the-shelf” with standard drawings and standard user documentation.

Standard configuration

• Single system with building block modular design
• Internal rectifier input switch Q1
• 6-pulse rectifier bridge with input isolation transformer
• Digital control card GCAU
• Output filter L1-C1 ripple voltage <5 % RMS without battery
• Rectifier F1 fuse and rectifier shunt R2
• Blocking diode V21
• Multi-functional LCD with 2 LEDs indicate the system status
• Tropicalized control electronics boards
• Common fault remote alarm
• Floor mounted cabinet with external IP21 protection and IP20 with open doors
• Cabinet colour RAL 7035
• Power and control cable marking
• Detailed 3-D layout and component marking presented on rear door
• Door able to open to180° with three key locks
• Bottom cable entry
• Input / battery / output terminals X1, X2 and X3
• » Standard labeling / nameplate

Options

The standard system can be enhanced by the additional options.  To provide exact solutions for each application, we offer a wide range of options:

System

• Parallel redundant configuration with load sharing
• Special mains input voltages (180 – 690 V) and frequency 60 Hz
• DC ripple filter 1 % & 0.1 %
• 12 pulse rectifier with isolation transformer
• Rectifier input MCB or fuse
• Battery MCB, fuse or switch in rectifier
• Battery MCB or fuse box
• Load MCB, fuse or switch
• Diode dropper
• DC distribution
• Battery installed inside the rectifier cabinet

Alarms / signaling / measurement

• LED alarm indicators in front panel
• Relay cards 2 x 8 free contacts
• Additional analog meters
• Low electrolyte level alarm
• Audible alarm
• Temperature charging compensation sensors & cables
• Temperature alarm
• High DC ripple voltage alarm
• Cable drop compensation
• Battery circuit failure alarm
• Ground fault alarm
• High rate interlock

Control options

• Remote rectifier shutdown command
• Remote forced floating charge command
• Remote room fan control
• Remote alarm reset
• Remote high rate charge command

Communication

• RS232 / RS485 interface
• RS232 / RS485 Modbus protocol
• TCP / IP interface
• Protocol converters (Profibus DP, J-bus)
• Monitoring and management software
• Modem

Mechanical

• Interior cabinet light, AC single phase socket & cabinet heater
• Protection up to IP54
• Special colour
• Vermin proof protection plates
• Low smoke wiring (halogen-free)
• Special markings
• Top cable entry
• Air filters at air inlet
• Ventilation 100 % redundant

Additional options are available on request